Formwork accessories
komplektuyushhie-k-opalubki-04

Hinged nut-washer DW 15120х120
It is used in a set with an anchor rod for fixing formwork panels.
Due to the wide and strong washer (plate), the support area on the formwork panel increases.
The connection of the panels is provided at an angle of inclination up to 10 °.
Permissible working load 90 kN.
Coating – zinc plating.

komplektuyushhie-k-opalubki-05

Nut DW 15D90
It is used in a set with an anchor rod for fixing formwork panels.
Made of high-strength chavun.
Permissible working load 90 kN.
Coating – zinc plating.

komplektuyushhie-k-opalubki-02

Rod anchor DW 15
For connection and maintenance of formwork panels in the design position. The formwork tie is used with different types of nuts that are installed on both sides.
The anchor rod in combination with the nuts directly perceive the pressure of the concrete mix.
In section it has a special shape, which excludes contamination of the thread of the anchor rod with concrete.
Thread pitch 15 mm.
Permissible working load 90 kN.
Length up to 3 m.

komplektuyushhie-k-opalubki-01

End anchor
It is a part of a tightening screw (anchor rod) with an end stop perpendicularly fixed at the end.
It is used to connect wall and universal panels when forming columns and end ends of walls.

komplektuyushhie-k-opalubki-03

Cast waterstop (type G)
they are used in cases of need for waterproofing walls (sewage treatment plants, swimming pools, etc.), as water cut-off in places where screeds are installed.
Size (diameter) -120x120x2mm, Ø65mm, 110mm.
Length 112mm (type G65 and S), 130mm (type G110).
Thread diameter 15 / 17mm.
Ultimate load 190kN.

komplektuyushhie-k-opalubki-10

Moisture-resistant laminated plywood
High quality construction material coated on both sides with a special phenolic film laminated. The outer and inner layers of plywood are birch veneer.
Sheet size – 2500×1250 mm.

komplektuyushhie-k-opalubki-08

Molding oil F10
It is used to protect the form-forming surface of formwork panels and is necessary as a separation layer between the concrete mixture and the formwork surface. Suitable for formwork materials made of wood, metal, film faced plywood.
Perfect concrete surface quality, easy and clean demoulding.

komplektuyushhie-k-opalubki-09

Technical pipe DR 22U
The plastic pipe is used to protect the tie screws (anchor rods) of the formwork in order to prevent the supply of concrete residues to it.
The length of the tube is determined by the wall thickness of the monolithic structure, taking into account the height of the two cones fixed in it. In winter, HDPE pipe is often used instead of PVC pipe, being a more plastic material.

komplektuyushhie-k-opalubki-07

Protective cone
It is used with a technical pipe in order to prevent the appearance of concrete residues on the anchor rod and ensures a snug fit to the forming surface of the formwork panel.

komplektuyushhie-k-opalubki-06

Plug
It is used to protect openings in formwork panels and to close unused openings of universal panels, preventing leakage of concrete mix, as well as holes in the concrete structure remaining from the anchor rods after dismantling the formwork.

komplektuyushhie-k-opalubki-11

Retainers
The protective layer of the reinforcing cage in monolithic construction is formed by plastic reinforcement clamps, the main task of which is to provide a gap between the formwork and the reinforcing cage, regulated by the project.